DUMP TRAILER Energy UNIT- SINGLE ACTING
This power unit has a energy up gravity down circuit. Commence the motor to lengthen the cylinder and activate the solenoid valve to retract the circuit. Manual override to solenoid valve is often offered if essential. Also a strain compen sated flow manage is usually additional on the circuit to control the descent speed with the cylinder.
Remark: Please check with our revenue engineer for that distinctive pump displacement, motor power or tank capability.
one. This energy unit is of S3 duty cycle, i.e., non-continuous operation, thirty seconds on and 270 seconds off.
two. Clean all the hydraulic components concerned prior to set up of the power unit.
3. Viscosity on the hydraulic oil shoud be 15~46 cst,which need to also be clean and cost-free of impurities.N46 hydraulic oil is advised.
four. The power unit should be mounted horizontally.
five. Check the oil level while in the tank just after the preliminary operating with the electrical power unit.
6. Oil shifting is required after the first a hundred operation hours, afterwards after every 3000 hrs.
DUMP TRAILER Power UNIT-DOUBLE ACTING
This electrical power unit has a energy up power down circuit with load holding on both A & B ports. A strain compensatred movement control could be extra to circuit to manage the decent pace of your cylinder.
one. This power unit is of S3 duty cycle, i.e., non-continuous operation, 30 seconds on and 270 seconds off.
two. Clean the many hydraulic components concerned before set up of the power unit.
three. Viscosity on the hydraulic oil shoud be 15~46 cst, which need to also be clean and absolutely free of impurities. N46 hydraulic oil is encouraged.
4. The energy unit must be mounted horizontally.
five. Check the oil degree from the tank right after the first running in the electrical power unit.
six. Oil modifying is required following the preliminary 100 operation hours, afterwards once just about every 3000 hours.