TF Sort Flanges
Model TF flanges are made from the identical high-strength cast iron since the S flanges, but are built to accommodate the international typical Taper Lock bushing for quick set up and removal
TF Kind flanges permit for mounting the bushing around the front (hub) side with the flange
TF flanges can be found in sizes six by way of 16 and can be utilised with any style of sleeve as pictured on page SF-5
TR Variety Flanges
TR flanges are equivalent to the TF fashion, but make it possible for for that Taper Lock Bushing to become mounted and eliminated from
the reverse or serration side with the flange
The restricted torque ratings with the Taper Lock Bushings permit TR flanges to only be applied with EPDM or Neoprene sleeves
Different bushing sizes are utilised, so they have distinct optimum bores compared to the TF flanges
Sizes 6 by 16 can be found
Taper-Lock Bushings
The marketplace common taper lock bushing is usually a split style permitting a compression match on the flange to your shaft with 
out set screws
The easy layout can make the installation and elimination quick while the 8° taper grips tight and presents outstanding concentricity
A Decreased level of inventory could be achieved because of the many other electrical power transmission components that use Taper Lock Bushings like: sheaves, sprockets, and pulleys
will not supply the Taper-Lock Bushings themselves as they are widely readily available from other manufacturers
