SMR Gearbox Installation
Satisfactory functionality depends on suitable installation. lubrication and upkeep. for that reason it is crucial that the directions inside the set up and maintenance leaflet. provided with each and every gearbox. are followed very carefully. some of the critical elements of belt and torque-arm set up are listed beneath.
1. Install pulley on gearbox input shaft as near towards the reducer achievable, and mount reducer on driven shaft as near to bearing as useful. failure to do this will bring about extra loads during the input shaft bearings and output bearings and could trigger their premature failure.
2. Install motor and wedge belt drive using the belt pull at roughly 90° on the center line between driven and input shafts. this will likely allow tensioning from the wedge belt drive using the torque arm which really should preferably be in tension. if output hub runs anti-clockwise. torque arm must be positioned the best.
3. lnstall torque-arm fulcrum on a rigid help to ensure the torque-arm will likely be at about ideal angles for the center line with the driven shaft as well as the torque arm situation bolt. make certain there exists sufficient consider up within the turnbuckle for belt stress adjustment.
Maintain shut.
Bell drive could be positioned in any easy postion. if your torque arm should be to be utilized to tighten the belts, the drive must be at about tight angle on the line involving the input and output shafts.
Bell drive may very well be situated towards the suitable if sought after.
If output hub rotates clock-wise. position belt drive and torque arm in opposite route to that proven in the illustration.
Torque arm and belt get up.
Torque arm could possibly be mounted for the proper if preferred.