Power UNITS FOR LIFT TABLE one
General Description
This energy unit is made solely for that little lift table,Consisting of large pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This power unit has become broadly utilized inside the business of logistic products for instance minifork lift, scissors lift and ariel functioning platforms. The lower-ing motion is managed from the solenoid valve using the pace controlled from the adjustable needle valve.
Power UNITS FOR LIFT TABLE two
Basic Description
This electrical power unit is made exclusively to the medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing motion is actived from the solenoid valve and the velocity managed through the adjustable needle valve. When the lift rises to a substantial positoin, however the energy supply is minimize, the lowering movement is managed from the guide override function.
Energy UNITS FOR LIFT TABLE 3
Standard Description
This electrical power unit is made solely for that huge lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived by the solenoid valve along with the pace managed by a pressure compensated flow manage valve.
Electrical power UNITS FOR LIFT TABLE four
General Description
This energy unit is intended exclusively to the huge lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived by the solenoid valve and the speed managed through the adjustable needle valve. Once the lift rises to a higher positoin, but the energy provide is minimize, the lowering movement is managed from the guide override perform.
Unique Notes
one. This electrical power unit is of S3 duty cycle, which may only do the job intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean each of the hydraulic parts concerned before set up of the energy unit.
3. Viscosity on the oil shoud be 15~46 cst,which need to also be clean and free of impurities.N46 hydraulic oil is encouraged.
4. Oil shifting is needed right after the original 100 operation hrs,afterwards as soon as each 3000 hrs.
5. The energy unit shown is made to be mounted vertically.