The EP Greenhouse geared motor is a compact and lightweight reduction gearbox with a built-in limit switch system that’s suitable for assembly of a locally available electric motor. The gear motor can be used in manually-controlled or climate-controlled ventilation and display screen systems in greenhouses. The quick and easy-to-install EP gear motor is rainproof and windproof. The gear driver has a high protection course (IP65) and can be utilized within an ambient temperature of 0-60 °C.
The low-noise reducer for Greenhouse has a gearwheel transmission and a worm wheel transmission, which are integrated in an aluminum precision housing. The self-braking worm wheel tranny ensures that the drive shaft is usually locked when the reduction gear reducer isn’t running. The completely sealed reduction gear reducer has an expansion chamber with a diaphragm to keep the gear essential oil at a minimal pressure under all conditions, even at high temperature ranges. Thanks to the utilization of an growth chamber, the gear driver can be installed in any position. There are no limitations, because there 
is no need for a bleed connect. The sealed reduction geared motor keeps the gear essential oil of the gear motor in ideal condition for its entire operating lifetime. The gear driver is suitable for discontinuous use, working course s3-30%, with a maximum activation period of 25 minutes.
The Gear box reduction gear driver has an FT85 motor assembly flange, to which a suitable IEC standard motor can easily be installed (EN 50347).
The Gear box includes a rotating limit switch system with operating switches and circuit breakers (NC contacts) for turning off at the end positions. The limit change system is installed within an integrated chamber and is certainly enclosed by an impact-resistant plastic cover. The limit change system is obtainable and easy to adjust. The limit switch system’s optimum switching range is 40 or 64 revolutions of the drive shaft. The cabling is connected in spring-clip connections. The gearbox has an IP68 M16 x 1.5 cable gland (5-9 mm cable) for the cable feed-through.
The reducer for greenhouse includes 16 teeth 5/8”x3/8” sprockets, keys and fasteners. The accompanying chain couplings and assembly plates can be found as accessories.
Optimum drive torque of 150 Nm or 450 Nm.
Rotational speeds of 3 or 5 rpm for a mains frequency of 50 Hz or 3.6 or 6 rpm for a mains frequency of 60 Hz in case of software of 4-pole electric motor.
Protection class IP65.
May be used in ambient temperature ranges of 0-60°C.
Suitable for discontinuous use, operating class s3-30%, optimum activation time 25 mins.
Equipped as regular with 16-tooth galvanised chain coupling 5/8″x3/8″.
FT85 motor assembly flange for installing IEC standard motor (EN 50347).
Maximum switching selection of limit switch system 40 or 64 revolutions of the drive shaft.
IP68 M16x1.5 cable gland for cable feedthrough (5-9 mm cable).